iVision IV-WP866PL, Руководство пользователя

Страница: 22 / 24

- 21 -
you can operate on the keyboard to stop the auto scan. Operation is as below:
a. Input 138(108)
b. Press PREVIEW key
The Auto Scan can also be stopped by any operation on the joystick of the keyboard.
7.7 Configure, Activate and Idle the Default Position function
The unit has default position function. The user can configure default position for a key monitoring area according to
actual conditions. If not operated after 2 minutes, the IR Low-speed dome camera will automatically turn to the default
position and monitor.
1. Configure the Default Position
Move the IR Low-speed Dome Camera to a key monitoring area through controlling keyboard, adjust the zooming
ratio well, then enter number “164”(124) from the keyboard and press the “PREVIEW” key, then the configuration is
successful.
2. Activate and idle the Default Position function
The user can activate or idle the function of default position through the keyboard. Enter number “162”(122) and press the
“PREVIEW” key, the function is activated. Enter number “163”(123) and press the “PREVIEW” key, the function is idled.
7.8 Open and close the menu of camera module
The unit has a function as “configuring the parameters of the Camera Module”. Users can open and close the menu
of the camera module by invoking 145 and 146 “preset positions”. After entering the menu, users can configure the
camera module conveniently. The operation is as below:
1. Open the menu of the camera module
a. Input 145(95)
b. Press PREVIEW key.
2. Close the menu of the camera module
a. Input 146(96)
b. Press PREVIEW key.
Attention: If the camera module doesn’t have menu function, this function with the unit is unavailable.
VIII. Table for the functions of the IR Low-speed dome camera
Notice: “PELCO-D” and “PELCO-P” protocols have no corresponding orders for part of the special functions, so we
converted functions of some of the commonly-used orders, generally converting in the way of “invoking preset position/
configuring preset position”. Order converting correspondence is shown in the following table:
Invoke “preset
position” No.
Keyboard operation meaning
Invoke “preset
position” No.
Keyboard operation meaning
130 Configure left limiting position 125 IR lamps to be triggered by
photosensitive resistor (default)
131 Configure right limiting position 126 IR lamps to be triggered by
camera module