IVIE MPS 2300, Руководство пользователя

Страница: 23 / 48

Basic
Instructions
Ivie Technologies
MPS 2300
Preventing Output
Clipping.
25V Systems.
Pre-Out/Amp-In.
Insertion of signal
Insertion of signal processing- remove jumper, patch
processing.
in equipment.
This method of setting the PowerLimit control is
based on the speaker manufacturer’s ratings. Follow
personal experience in conservatively allowing for
differences between ratings and real-world
performance.
To allow full output but prevent clipping:
1. Put the PowerLimit control in the out position (full
clockwise).
2 . Play signal (preferably music) and increase the
Master Volume until the Clip LED (on rear) of the
affected channel lights.
3 . Dial in (counter-clockwise) just enough limiting to
extinguish the LED.
4 . Increase the volume a little more. If the LED lights
again, dial in just enough limiting to put it out.
5 . Repeat with the other zone.
Note- the 100% setting on the PowerLimit control should
be a very close first setting.
Output voltage can be limited to 25V if required for a
25V system:
1.
Use the 4-8 ohm speaker voltage hook-up and
Speaker Impedance switch setting.
2 . Adjust the PowerLimit to the 25V setting.
The unbalanced barrier patch point between the mixer and
amplifier sections is post Music and Page Volume and AUX
inputs but pre-Master Volume and tone controls. Removing
jumper breaks connection.