General Installation Guide
This SkidWeigh Classic SC5 / SC5-OEM systems installation & calibration guide describes how to install, calibrate,
test and use your electric pallet truck on-board weighing system. Following the instructions in this guide will enable
you to get your system setup and operating quickly. In the event that you require additional assistance, please
contact customer support via e-mail at [email protected], visit
address and or contact number below:
Integrated Visual Data Technology Inc.
3439 Whilabout Terrace, Oakville, ON, Canada, L6L 0A7
Phone: 905-469-0985
Safety
Always disconnect the vehicle battery while installing SkidWeigh systems or any other electronic product.
Make sure that unit, pressure transducer and any other associated cables are securely mounted and do not impede any
of the vehicle’s controls. Use care when routing the component cables. Route the cables where they will be protected.
Use commonly accepted install practices for after market industrial vehicle electronic devices.
The installation of the SkidWeigh systems should only be performed by a lift truck dealer technician or end user with
electro and hydraulic experience.
Here are two acceptable methods of making a wire connections:
* Soldering your connections (recommended)
* Crimp connectors (with the use of the proper crimping tool)
Regardless of the method you choose, ensure that the connection is mechanically sound and properly insulated. Use
high quality electrical tape and shrink tubing where necessary. This product is connected directly to the vehicle’s ignition
switch, operating voltage from 12 to 55 VDC.
Electro-Magnetic Compatibility
CE conformity to EC directive 89/336 (EMC) by application of harmonized standards: Interference stability EN 61000-6-2
and EN 61326-1 interference emit EN 61000-6-3, EN 61326-1 for the pressure transducer.
SkidWeigh Classic SC5 Series
Our policy is one of continuous improvement and the information in this document is subject to change without notice.
Check that software version displayed on LED is the one applicable for your application.
Overview of Components
The standard
SkidWeigh Classic SC5
Series
check weighing system consist of the following components:
* Digital indicator with wiring harness, mounting bracket and anti-vibration mount
* Hydraulic pressure transducer with 3 wires cable
* Installation & Calibration manual and operator usage instruction
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
