IV Produkt Envistar Top, Руководство по сборке

Страница: 34 / 44

Page 34 (44)
Ver 2_en_2022-06-27
Assembly Instructions
Envistar Top
ivprodukt.docfactory.com
Order Portal
9 CONNECT COIL, ELECTRIC
9.1 Connect heating coil, electric (ETKB-EV), (ETAB-SV)
00176
Electrical voltage can cause electric shock, burns and death. The product
must not be energised during assembly.
Electrical connection and electrical work may only be carried out by a
qualified electrician.
For initial start-up of the unit, see Operation and Maintenance of the unit
on IV Produkt's order portal .
•
•
Risk of life-threatening or serious personal injury.
WARNING!
00073
3
2
1
Figure: Air heater electric
1. Cover for connection box
2. Connection box - not to be mounted upwards
3. Connection box - not to be mounted downwards
The distance from the sheet metal casing of the air heater to wood or other combustible mate-
rial, must be 100 mm or more.
9.1.1 Heating coil, electric (ETKB-EV), (ETAB-SV) in duct
The air heater, adapted for assembly in duct systems, requires separate connection. The
air flow direction through the air heater must correspond with the direction arrow on the air
heater. See "12 DUCT CONNECTION, DUCT ACCESSORIES”, page 39.
The heater can be connected in horizontal or vertical ducts with the connection box to the
side.
The distance from the air heater to duct elbows, dampers, filters or the like, should be at least
the distance corresponding to the diagonal measurement of the heater (from corner to corner
in the heater’s duct section). If the distance is smaller, the air stream through the heater can
become uneven and the overheat protection can be tripped.
The air heater is insulated according to the applicable rules for ventilation ducts/ventilation
units and with non-combustible insulating material. The type plate and warning plate must
be fully visible and the cover must be possible to open. The air heater must be accessible for
replacement and servicing.