IV Produkt Envistar Top, Руководство по сборке

Страница: 18 / 44

Page 18 (44)
Ver 2_en_2022-06-27
Assembly Instructions
Envistar Top
ivprodukt.docfactory.com
Order Portal
6 ASSEMBLY, GENERAL
Read and follow each step carefully to avoid making errors and causing personal injury or
damage to surroundings or unit. See "1 SAFETY”, page 5, "4 LIFT THE UNIT”, page 14,
"5 PREPARE ASSEMBLY”, page 17 and "7 ASSEMBLE, VERSIONS”, page 23.
For example of set-up drawing and explanations of drawing symbols, see "2.5 Symbols on
drawings and in manual”, page 10.
00176
Electrical voltage can cause electric shock, burns and death. The product
must not be energised during assembly.
Electrical connection and electrical work may only be carried out by a
qualified electrician.
For initial start-up of the unit, see Operation and Maintenance of the unit
on IV Produkt's order portal .
•
•
Risk of life-threatening or serious personal injury.
WARNING!
00178
Art. Nr. 19194-0013
Follow the lifting and assembly instructions in this manual.
Use lifting equipment where available.
Use appropriate protective equipment.
Exercise caution when working between unit parts.
•
•
•
•
High unit parts, as well as unit parts with a high or offset centre of gravity,
mean a greater risk of tipping.
Risk of life-threatening or serious crushing or compression
injury.
WARNING!
6.1 Assemble adjuster foot (accessory), adjust the height
The unit should tilt slightly forward (towards the inspection side) for con-
densation runoff and drainage. The inclination may be a maximum of 3
mm/m.
1. Tighten the lower locking nut (3) on the support foot (4).
00130
1
2
3
4
2. Insert the top of the support foot into the hole of the hat profile and tighten the upper
locking nut (2). The distance between the floor and the bottom (1) shall be 120 to 160 mm.
3. Use a spirit level and make sure that the unit is level along the inspection side/back.
4. Adjust the height and inclination of the support by turning the upper and lower nuts.
5. Secure all support feet by tightening both the top and bottom nut.