9
Chargemaster Pinner
5200710 Rev. H
5. OPERATION
CAUTION
–
ELECTRICAL SHOCK HAZARD
Do not touch Charging Bar during operation.
CAUTION
– FIRE HAZARD
Do not operate equipment in close proximity to any flammable solvents or
flammable materials.
1. Before energizing any power supply:
• Ensure that all power supplies are properly grounded.
• Ensure that all charging bars have been properly located, positioned and
installed.
• Ensure all requirements printed in the applicable power supply instructions
have been fully complied with.
2. After the above checks have been performed, simply energize each power supply
to operate the charging bars.
3. Setting Strength of Pinning:
• If charging bar is operating in electrical stress condition (evident by purple
glow on pins and slight sizzling noise), slowly decrease operating voltage of
the power supply.
• If adhesion or pinning strength is not adequate, slowly increase operating
voltage of the power supply.
4. Always turn the power supply OFF when the system is not in use. For safety
and ease of operation, it is recommended to connect the power supply line cord
to the electrical system of the machine in such a manner that the power supply
is only energized when the machine is in operation.
NOTE
– Sustained operation in electrical stress will likely interfere with
operation of the charging system. Electrical stress reduces output voltage
from the power supply and suppresses the charging process. Sustained
stressed operation may also damage the bar and power supply.
