not obstruct the front grille with any objects.
The unit can operate embedded, but with a reduction in output.
In case the front louver is not enough, the exit is either total or partially obstructed or due to
its placement it will receive hot air from another device, we recommend, in case it is not
possible to change the location of the machine, TO INSTALL A WATER COOLED UNIT.
IT IS IMPORTANT THAT THE WATER PIPING DO NOT PASS BY OR NEAR SOURCES
OF HEAT SO AS NOT TO LOSE ICE PRODUCTION.
The machines expel hot air through the grids and this air has to go to the environment and
not accumulate. This is particularly important with the air ejected from the back of the
machines: you must leave a space to the wall of a minimum 10 cm, allowing air to flow from
behind and with an exit so that there is a renewal of the same, avoiding the formation of hot
air pockets in this area that could reduce the ice production of the machine and even activate
its overheating protector and cause it to stop.
THREAD THE SUPPORT LEGS TO THE BASE OF THE MACHINE ON THE
HOUSING SET TO SUCH END AND REGULATE THE HEIGHT AS TO HAVE THE
EQUIPMENT PERFECTLY LEVELED.
Exits/renewals of the air between the rear of the machine and the wall
must be provided for.
