ITT Goulds Pumps Trash Hog II, Инструкция по установке, эксплуатации и обслуживанию

Страница: 25 / 51

Figure 10: Horizontal correction of the motor
5. Repeat the previous steps until the permitted reading value is achieved.
4.1.3.14 Perform complete alignment for a vertical correction
1. Set the angular and parallel dial indicators to zero at the top-center position (12 o’clock) of the driver
coupling half (Y).
2. Rotate the indicators to the bottom-center position (6 o’clock).
3. Record the indicator readings.
4. Make corrections according to the separate instructions for angular and parallel alignment until you
obtain the permitted reading values.
4.1.3.15 Perform complete alignment for a horizontal correction
1. Set the angular and parallel dial indicators to zero at the left side of the driver coupling half (Y), 90°
from the top-center position (9 o’clock).
2. Rotate the indicators through the top-center position to the right side, 180° from the start position
(3 o’clock).
3. Record the indicator readings.
4. Make corrections according to the separate instructions for angular and parallel alignment until you
obtain the permitted reading values.
4.1.3.16 V-Belt Drive Installation Checks
Use the following steps and guidelines to make sure that the v-belt drive is properly installed and that the
belts are properly tensioned.
CAUTION:
The unit must not be operated without the proper drive guard in place. Operating the unit with-
out the drive guard in place could result in personal injury to operating personnel.
1. Alignment must be maintained for full power transmission, minimum vibration, and long drive life. A
dial indicator can be used to check runout on the periphery and face of each sheave. A straight
edge can be used to check the alignment of pump and drive sheaves.
4.1 Pre-installation
Model Trash Hog II Installation, Operation, and Maintenance Manual 23