Display
The display performance is slow
z
The temperature may be too cold. Move the computer to a warmer operating environment.
I can’t read the display
z
Adjust the brightness level using
FN
+
F6
and
FN
+
F7
.
z
The automatic power-saving mode may have shut off (suspended) the computer. Press any key to
resume.
z
If the display brightness is unreadable after a resume or reboot but is easily adjusted with
FN
+
F6
and
FN
+
F7
, you may have set Stealth mode in the Setup Utility. If you disable Stealth mode, the
display and backlight will operate normally.
The underlined, inverse, and hypertext characters are difficult to read on the screen
z
Change the color scheme. From the Start Menu select Settings, Control Panel, choose Display,
and then tap the Appearance tab to make changes to the color scheme.
I can’t see the cursor while using the DOS editor
z
Press
FN
+
INSERT
to change from insert mode to overwrite mode to enable a block cursor.
When it defaults to insert mode, the DOS editor uses an underline cursor which is less visible than
the block cursor for overwrite mode.
The display appears to have random pixels darkened after scrolling
z
Contact your supervisor or your organization’s help desk for information about correcting this
problem.
I changed my display resolution, but I see no difference on the screen
z
Try restarting your computer for the changes to take effect.
72_0119_001
28 June 2004
© 2004 Itronix Corporation. All rights reserved.
GoBook III
®
Help
Page 72 of 80
GoBook III Help
7/5/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~h...