SCREW AIR COMPRESSOR OPERATOR’S MANUAL TM356-10270
English
17
Code 1641003212 - Edition 10/2020
to enter into Menu Selection Interface:
Level 1 menu screen
Level 1 menu screen
Press
or
to move the black cursor to RUN PARA. , press
enter button to pop up submenu:
parameters and run state parameters
as follows:
Fan current, Total run time, Total load time, This run time, This load time,Oil filter time, O-a
filter time, Air filter time, Lube time, Grease time, Belt time
etc.
In primary menu,, press the move button to move the black slider to the "USER PARA" menu,
press the shift button to switch to the following menu:
In this menu, Press shift button
Switch to the following interface requirements to enter a user
password
After showing this interface The first bit data of password started flashing press
or d
to modify the flashing data equal to the first bit of password
Press the shift button, move the cursor to the next data bit,similarly modify the third and fourth
Finally, press the Set
he system verify the password is correct,
switch to the following interface:
The upper right corner with "* "prompt said the
System has passed the password authentication
When in this menu(as shown above), press enter button , then the data of loading pressure
start to flash, users can press
to modify the data.
When finished, press Set Button to confirm and save. the controller will keep to confirm.
14.2.2 Early-Warning and Prompts
OIL FILTER LIFE END
RUN PARA.
USER PARA.
MOTOR(A) A-0100
B-0100 C-0100
FACTORY PARA.
MOD PARAMETER
LOAD PRES:
00.65MPa
PASSWORD:0***
LOAD PRES: *
00.65MPa
17
www.itmtools.com.au
