Itm Holemaker HMP45, Руководство оператора

Страница: 7 / 34

®
HMP45 OPERATOR’S MANUAL
www.holemaker.com 7
2.1 Installing and uninstalling the arbor
The arbor installation and uninstallation should be carried out when the machine is
turned off and disconnected from the air supply.
Installing the arbor:
a)
Raise the cutter guard (2) to the maximum height
b) Clean the inside of the spindle using a cotton cloth,
c) Before mounting, clean off the lubricant from the new arbor (3),
d) Place the arbor with the tang on top, and place it in the spindle,
e) By turning the arbor, align the tang to the appropriate slot in the spindle,
f) Using a light impact from the bottom side, drive the arbor into the spindle.
Uninstalling the arbor:
a)
Raise the guard, turn the spindle so that the opening in the spindle (1) is lined up with
the opening in the reducer body,
b) Place the drill drift (included as standard equipment) into the uncovered spindle
opening (1),
c) Hold down the arbor (3) with one hand,
d) Strike the drill drift with a hammer, taking care to not to damage the arbor,
e) Carefully remove the arbor from the socket in the spindle,
f) Remove the drill drift
1
2
3