Itm Holemaker HMP45, Руководство оператора

Страница: 17 / 34

®
HMP45 OPERATOR’S MANUAL
www.holemaker.com 17
3.1 Slides Adjustment
Use the feed handles (1) to move the sliding section of the drill to a position where the screws
(2) align with the holes (5) in the sliding section. Loosen each of these screws slightly, and
then using the feed handles slide the sliding section up and down several times until any
clearance between the pressure strip and the slider is even and aligned.
Once this has been completed, tighten screws (2) starting from the middle screw. The slider
should be located symmetrically relative to the middle screw. Next, tighten the neighboring
screws (2) moving the slider in the degree necessary for making them visible.
Then, tighten screws (3) until any noticeable resistance is felt. Tighten counter nut (4). The
screws (3) counteract the machining force and protect the pressure strip from shifting during
operation.
A
1
5
2
3, 4
Canceling clearance