Itm Holemaker HMP45, Руководство оператора

Страница: 5 / 34

®
HMP45 OPERATOR’S MANUAL
www.holemaker.com 5
9. Do not remove metal chips with bare hands, always use gloves.
10. Do not touch the spindle and cutting tool during work.
11. Cutting Tools must be fastened firmly.
12. Do not drill with blunt of damaged cutting tools.
13. Do not use annular cutters without a pilot pin, and arbors without an ejection spring.
Do not touch or replace the cutting tool with power source on
14. After use, always clean drilling machine from metal chips and cutting fluid.
15. Any maintenance and repair should be performed only when the machine is disconnected
from the air supply.
16. Before each use the machine should be checked for the presence of damage. Check
whether any of the parts are broken and all the that all parts are fasten properly.
17. In the case that the machine falls on a hard surface, from a height, is wet or is subjected
to other unfortunate events that could affect its technical state - work should be terminated
immediately and the machine should be sent to service for inspection as soon as possible.
This machine is not recommended to be used to drill on steel thinner than 10mm (3/8”).
On thin steel less than 10mm (3/8”) magnet’s adhesive power would be significantly
reduced which can cause machines failure or personal injury.
The pneumatic motor used in Holemaker HMP45 drilling machine is ATEX II2 G/D C IIC
T6;T4 certified, which is required for usage in explosion risk zones.
CAUTION: Never carry the drill by the motor’s air supply hose!