Itm Accutek III, Руководство по эксплуатации

Страница: 22 / 30

Testing Energy Level
MULTI-STRIKE IGNITION SYSTEMS MUST
BE OPERATED IN SINGLE STRIKE MODE
WHEN TESTING WITH THE ACCUTEK III.
11.1 When the MEASUREMENT switch is placed in the ENER-
GY position, the ACCUTEK III will display a relative read-
ing of energy being delivered to the ignition coil under test.
11.2 Place the TEST switch in the COIL/IGN position and the
MEASUREMENT switch in the ENERGY position.
11.3 If the engine has a primary harness junction box, check ener-
gy being supplied to the ignition coils by placing the HV-
TEST lead to each contact point on the terminal strip associ-
ated with an engine cylinder (engine running). Each primary
lead should be delivering the same energy potential to its
intended ignition coil. Should the energy level to any cylin-
der or cylinders be considerably higher or lower than the
average readings, this is an indication of a potential problem.
(Check individual components separately.)
11.4 When testing an unshielded ignition system, place the HV-
TEST lead to the ignition coil positive and compare readings
from all ignition coils. There should be minimal differences
in the readings if the ignition harness and ignition coils are in
good condition.
11.5 With the engine running, the ACCUTEK III will display a
relative measurement of energy being delivered to that igni-
tion coil.
www. .com
information@itm.com 1.800.561.8187