3
Installation
Figure 3.
Wall Mounting Hole Locations
To Mount the Module in an Advent Cabinet
1.
Remove AC panel power and disconnect the backup
battery(s).
2.
Remove the module cover and set it aside (Figure 2).
3.
Turn the module upside down and line up the holes on
the back-plate at the desired location (Figure 4).
4.
Secure the back-plate to the cabinet using three 1/4 -
inch #6-32 self-tapping screws (not included).
Figure 4.
Mounting the Module in an Advent Cabinet
To Mount the Module in a Concord
Cabinet
1.
Remove AC panel power and disconnect the backup
battery.
2.
Remove and discard the module cover (Figure 2).
3.
Insert a support standoff shown in Figure 5 (supplied
with panel) into the panel circuit board.
Figure 5.
Support Standoff
4.
Slide the module back-plate onto the two clips located
on the top-left corner or center of the cabinet
(Figure 6).
Ìi
The two mounting clips in the top-right corner of the
cabinet are designated for a receiver module, but if a
receiver module is not being used, the mounting clips
may be used for the 8 Zone Input Module.
5.
Push the lower-right corner of the module onto the sup-
port standoff (see detail in Figure 6).
6.
Gently press the module up and onto the cabinet side
tab.
Figure 6.
Mounting the Module in a Concord Cabinet
9712G02A.DSF
MOUNTING HOLES
REED SWITCH
HOLDER
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
MAGNET
CLIP
9712G11A.DSF
PANEL CABINET
(COVER NOT SHOWN)
MOUNTED MODULE
ROOM FOR 3RD
MODULE
MOUNT WITH
SELF TAPPING
SCREWS
SUPPORT STANDOFF
8573g64A.DSF
PANEL
END
MODULE
END
9712G08A.DSF
USABLE MOUNTING
CLIPS (6)
MOUNTED
MODULE
PANEL CABINET
(COVER NOT SHOWN)
DETAIL
SUPPORT STANDOFF
(Included with Concord
panel accessory package)
SIDE TAB
