Ithaca ITHERM 280, Руководство программиста

Страница: 190 / 318

* % 8 %.
#
not defined.) on a periodic bases. The value of n is the period in 100 MS
intervals. This command is saved through power cycles. Once set it
need not be set again, however you can set it the the same value
repeatedly as it is only saved if it is changed. In general it should not be
changed on a regular bases.
Where n = Intervel in 100 MS increments. IE 20 = 2 Seconds. Setting the value
to 0 disables the feature.
Note: Periodic status back can also be activated with the [ESC][EM]p command,
however it is not save during a power cycle.
[ESC] [EM]p<n>
Activate Periodic Status Back
ASCII [ESC] [EM] p<n>
Hexadecimal 1BH 19H 70H <n>
Decimal <27> <25> <112><n>
IPCL None
EPOS None
Description This command temporarily disables and enables the periodic status back
feature if previously activated with the [ESC][EM]P command.
Where n = 0 disables PSB and n = (non zero) Enables PSB at the interval
defined by the [ESC][EM]P command.
If not previously activated with the [ESC][EM]P command, this command will activate it
but not save the value through a power cycle.
Where n = Intervel in 100 MS increments. IE 20 = 2 Seconds. Setting the value
to 0 disables the feature.