11
50
10
0
14
0
80
160
Ø10
100
16
0
Application options
Connecting the yoke adapter to the LRF carriage
Place the carriage of the linear guide onto the profile and slide it over the yoke
adapter. Use the two grub screws (DIN 913-M5x5) to make height and angle
adjustments to the yoke adapter.
Ensure that the yoke adapter is aligned with the screw and the profile. The
maximum permissible angle error must not be exceeded.
As the yoke adapter is suspended in a movable arrangement via the gimbal
adapter, a range of adjustments can be made. You should select a setting that
is neutral in terms of angle and height, so that you can make full use of the
flexibility offered by the gimbal adapter during later use. To do this, position
the yoke adapter at the end of the travel range on the KGT and align it with the
carriage. Now fix the selected setting (grub screws) via the M8 screws at the
side.
You can now use the prepared M8 threaded bores to connect the carriage to
the set yoke adapter.
Depending on how the yoke adapter has been positioned for use, the connect-
ing threads can be central on the carriage or offset by 20 mm.
