Trouble-Shooting
■
Compression of lugs cannot be completed:
A. Applied cables or terminals are over-specification.
B. Operation instructions were not followed. The product or dies have
been already damaged.
C. Internal leakage: Contact your
KuDos®
service representatives.
■
Dies can not be set in place or can not be removed:
A. Deformed tool head or dies. Contact
KuDos®
service representatives.
B. Clean the grooves on the tool head to remove impediments.
C. Clean the die seats on the tool head to remove impediments.
■
The piston is stuck or is unable to retract after operation:
The piston may have been deformed by uneven stress distribution when
the product was operated with off-centered fittings. Contact
KuDos®
service representatives.
■
Replace any worn or damaged parts immediately. Do not use
parts not supplied by KuDos.
■
Contact KuDos® service representatives to request parts or for
problems not shown above.
■
Do NOT attempt to disassemble or repair the product.
■
KuDos hydraulic tools must be serviced by a qualified technician.
KuDos Mechanical
11
