Italiana Camini LITTLE, Инструкция по установке, использованию и обслуживанию

Страница: 16 / 77

- 16
-
THERMOTECHNICAL CHARACTERISTICS
Hopper capacity 15 kg
Efficiency 90,1 %
Available power 5,8 kW
Autonomy (min/max) 11/30 hours
Fuel consumption (min/max) 0,5/1,4 kg/h
Heatable volume* 145 m3
Weight including packaging 143 kg
Smoke duct diameter 80 mm
Air intake pipe diameter 40 mm
ENGLISH ENGLISH
ELECTRICAL CHARACTERISTICS
Power supply /- 10% 50 Hz
On/off switch Yes
Average power consumption 150 W
Power consumption during ignition 400 W
Remote control frequency (optional) Infrared
Protection on mains power supply * 2A, 250 Vac Fuse 5x20
Protection on electronic circuit board 2A, 250 Vac Fuse 5x20
SAFETY DEVICES:
THERMOCOUPLE:
placed at the smoke outlet to detect the temperature.
Turns the stove on and off and controls its operation based on
defined parameters.
AIR FLOW SENSOR:
installed at the intake duct, it trips when the combustion air fl ow is
not correct, causing low pressure problems in the smoke circuit.
SAFETY THERMOSTAT:
trips when the temperature inside the stove is too high.
It stops pellet loading, causing the stove to shut down.
* The heatable room dimensions are calculated on the basis of
pellets with an lhv of at least 4300 kcal/kg and home insulation in
compliance with Italian law 10/91, and subsequent changes toge -
ther with an expected heat output of 35 Kcal/m³ per hour.
* It is also important to consider the position of the stove in the
room to be heated.
N.B.
1) bear in mind that external devices may cause interference.
2) caution: live parts. Servicing and/or inspections must be carried out by qualified staff.
(Before carrying out any maintenance, disconnect the device from the mains power supply)
The Dealer can install an optional
on the AUX outlet (clean contact
on the pins) for controlling the
process of switching on and off (e.g. telephone remote,
local thermostat), located at the rear oh the stove. Can
be connected via special optional trestle (code 620550).
BACKUP BATTERY
A backup battery is found on the control board (3-Volt
CR 2032 battery).
Its malfunction is indicated with the following messages:
(not considered a defect but due to normal wear-and-
tear): ERR 1 - ERR 2.
For more detailed information, please contact the DEA-
LER who has performed the first 1st ignition.
FUSE
* two fuses are inserted on the socket
behind the stove, fitted with a switch one
is functional and the other is spare.
Connessionicavocombinatoretelefonico
Pin6epin7 Pin2epin6
620550 621240
pin 6
pin 7
SERIAL PORT
BACKUP
BATTERY
SMOKE
SPEED
THERMOCOUPLE
ROOM
SENSOR
P/TEMP.
ADJUSTMENT VENTILATION
ADJUSTMENT
FLOW
SENSOR
MAINS
SCREW FEEDER
MOTOR
SMOKE EXTRACTION
MOTOR VENTILATION IGNITION HEATING
ELEMENT
SAFETY
THERMOSTAT
*
*