IST GP-3000 DATA+, Руководство пользователя, Страница: 11 / 19

______________________________
IST PROLINE
<Safety Stop>
<Decompression>
･ The gray squares indicate blinking data
Safety Stop time
DECO STOP
Icon
Current depth
Pressure of
oxygen(PO2)
PGT graph
Decompression
stop depth
Decompression stop time
OLI graph
Total ascent time
______________________________
IST PROLINE
<Hold to push A switch> <Hold to push C switch>
(MIX change)
･
The gray square shows a blinking part.
Description of Functions
The dive mode has some modes. There are non-decompression dive mode, decompression dive
mode, safety stop condition, gauge dive mode, out of measurement range condition. The
functions of each dive mode are described below.
<Non-decompression mode>
It is the dive in which the NDL is remained.
<Gage mode>
The only functions that can be performed in this mode are the depth calculation, water
temperature measurement, and dive time measurement functions. Calculation functions, such
as PGT and OLI etc, are not performed. If you use this mode when diving, it is the GAGE mode
until 48 hours have elapsed. When diving by the gage mode, the safe stop isn't function.
<Decompression mode>
This mode is used for dives that last longer than the NDL. Until the advised depth is reached,
warning will continue. If you go to the surface, then after 10 minutes of a surface time, the
display will freeze and all calculation functions will stop. The mode will be automatically
switched to time mode after 48 hours have elapsed. This information is recorded in the dive log.
After calculations have stopped, you can switch only to log mode, profile mode, PC transfer
mode.
<Push A, B, C switch>
EL back light is on from 4-5 seconds.
<Safety Stop condition>
This shows recommended safety stop time in dive mode. If user dives descent over 9.9m, then
Water temperature
Max.
depth
Dive
time
Oxygen
percentage
MIX Icon blinks