MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 6. 2017
22
6.4. BOTTOM SLAT IS NOT HORIZONTAL WHEN IT REACHES THE TOP:
The guide rails are parallel but not perpendicular to the box. First check whether the box is perfectly level, then
measure along the diagonals and correct the installation.
6.5. BOTTOM SLAT DROPS OUT OF THE LATERAL GUIDE RAILS:
Check whether the end stops are fitted at the bottom of the guide rails.
6.6. THERE IS TOO LITTLE TENSION ON THE FABRIC; THE BOTTOM SLAT STICKS
OR JAMS WHEN THE SCREEN IS LOWERED OR RAISED:
Check the alignment of the guide rails; perhaps the bottom slat is being jammed at a point where the guide rails
are too close together.
The zipper is not fitted into the grey U-shaped part of the plastic guide profile.
The bottom slat is not hanging from the fabric but rather is resting on the window sill or another object.
6.7. CREASING AND BILLOWING OF THE SCREEN:
Box and/or guide rail is not perfectly level. Check both with a spirit level; refer to 2.6.
6.8.
THE MOTOR’S DIRECTION OF THE ROTATION DOES NOT MATCH THE ARROWS
ON THE SWITCH:
Exchange the brown wire and black wire in the switch.
6.9. THE SCREENS DO NOT STOP, THEY JUST CONTINUE TO ROLL UP AND DOWN:
Use a relay box (RI2).
6.10. AUTOMATIC OPERATION DOES NOT OPERATE PROPERLY:
Refer to assembly instructions: wind/sun automatic controller
6.11. THE BOX IS SAGGING IN THE MIDDLE:
Fit a mounting bracket at the middle of the box, or secure the middle of the box to the mounting surface in some
other manner. Refer to 3.2..
6.12. TO REPLACE THE FABRIC, PERFORM THE FOLLOWING STEPS:
•
Roll the entire screen back onto the fabric roll if that is still possible.
•
Remove the cover.
