Page 5 of 12
TTI-10 Iss.02 – 07/11
HANDLING
General advice
Clean only with a damp cloth. Do not wet or allow moisture to penetrate the unit. Do not use solvents or abrasive
materials.
Please store the measuring instrument in a dry and clean place.
Avoid any force like shocks or pressure to the instrument.
Do not use force to connect the probe or interface plugs in.
If no sensor is connected to the instrument while switching on, “open” shows on the display (Please refer to chapter
error codes/troubleshooting).
A retractable stand on the back of the instrument allows it to be used as a bench top instrument.
This equipment contains no user-serviceable parts. Refer all repairs to qualified service personnel. Contact Isothermal
Technology or one of our appointed distributors for details of approved service outlets
Operation
Before switching on the instrument, connect the probe or probes to the instrument
and insert the battery (Please refer to Power supply/changing the battery). The input
connectors are labelled “1” and “2”.
Switching on and off
By operating the ON/OFF-key the instrument switched on or off. After switching on
the instrument indicates a full segment test for 15 seconds, then it starts to function in
measurement mode indicating the actual measurement value.
Menu
The adjustments of the instruments function such as measurement value, calibration of probes, deactivation of
channels are selected from the menu structure. Enter into the main menu by pushing [ENTER/MENU]. Use the up
and down keys [
] to select the required menu. Push [ESC] to revert back to the measuring mode.
