EMC INFORMATION
This product meets the requirements of the European
Directive on Electromagnetic Compatibility (EMC)
89/336/EEC as amended by EC Directive 92/31/EEC
and the European Low Voltage Directive 73/25/EEC,
amended by 93/68/EEC.
The product meets the susceptibility requirements of
EN 50082-1, criterion B.
CE
System
Identification
Publication
Description
ISO3864
Caution
(Refer to
this leaflet)
IEC 417
Caution
Hot
Surface
Electrical Safety
This equipment must be correctly earthed.
This equipment is a Class 1 Appliance. A protective
earth is used to ensure the conductive parts can not
become live in the event of a failure of the insulation.
The protective conductor of the flexible mains cable
which is coloured green / yellow MUST be connected
to a suitable earth.
The Blue conductor should be connected to Neutral
and the Brown conductor to Live (Line).
Warning:
Internal Mains Voltage Hazard.
Do not remove the panels.
There are no user serviceable parts inside. Contact
your nearest Isotech agent for repair.
Voltage transients on the supply must not exceed
2.5kV.
Conductive pollution, eg Carbon dust, must be
excluded from the apparatus. EN61010 pollution
degree 2.
Environmental Ratings
Operating Temperature
5 - 35°C
Relative Humidity
5 - 95%, non condensing
Isotech North America
158 Brentwood Drive, Unit 4 Colchester, VT 05446
Telephone: 802-863-8050 Fax: 802-863-8125
[email protected] www.isotechna.com
The photo on the right
shows the correct position of
the Quick-Cal stand.
Please note : The above stand is for the high temperature
Quick-Cal only. The stand for the low temperature Quick-
Cal includes an additional upright as the unit does not
require a power entry cable.
The Quick Cal may be operated in any orientation or as a
handheld device. For convenience a stand is provided to
allow for vertical operation.
GUARANTEE
This instrument has been manufactured to exacting
standards and is guaranteed for twelve months
against electrical break-down or mechanical failure
caused through defective material or workmanship,
provided the failure is not the result of misuse. In the
event of failure covered by this guarantee, the
instrument must be returned, carriage paid, to the
supplier for examination and will be replaced or
repaired at our option.
FRAGILE CERAMIC AND/OR GLASS PARTS ARE
NOT COVERED BY THIS GUARANTEE.
INTERFERENCE WITH, OR FAILURE TO
PROPERLY MAINTAIN THIS INSTRUMENT MAY
INVALIDATE THIS GUARANTEE.
RECOMMENDATION
The life of your
ISOTECH
Instrument will be
prolonged if it is kept clean and free from general
dust and debris.
The photo on the right
shows the correct assembly
of the Quick-Cal stand.
