RF Pairing
1. Receiver Unit
: Insert a slender object into the hole and keep it depressed for
approximately 5 seconds until the red LED starts flashing.
2. Transmitter Unit
: Turn the SYSTEM switch to OFF. Press the
Menu
button. Press and hold
the
Tech Set
button for 5 seconds to access the Installer Settings screens. Press the
Next
Step
button until “LE” is displayed on the LCD, then press and hold second key from the
top for 5 seconds until “LE” is flashed, then release. When the red LED on the receiver
unit stops flashing, this indicates the code transmission was successful.
Note: For a Master/Slave setup, a Receiver Unit is required on each PTAC. Each
Receiver Unit (Master and Slave) must be activated as described in step 1 above,
then each receiver is paired with the Transmitter Unit as described in step 2.
Set Time
Follow the steps below to set the day of the week and current time:
1. Press the
Menu
button.
2. Press
Set Time
button.
3. The day of the week will be flashing. Use the “+” or “-” key to select the current day of
the week.
4. Press the
Next Step
button.
5. The current hour will be flashing. Use the “+” or “-” key to select the current hour. When
using the 12 hour time setting, ensure “AM” or “PM” is appropriately selected.
6. Press the
Next Step
button.
7. The current minutes will be flashing. Use the “+” or “-” key to select the current minutes.
8. Press the
Done
button.
13
RF Pairing
