ISKO KOCH GmbH, Egerländer Str. 28, 95448 Bayreuth
Instruction Manual page 12 to 21
ISKO KOCH GmbH, Egerländer Str. 28, 95448 Bayreuth
Sliding Tray
There is a sliding tray interface option (factory fitted) for the Delta standing frame which allows the
tray to be slid closer to the user once they are in a standing position.
To bring the tray closer to the user, undo the two knobs (pos. 18, pic. 5.7) on the underside edges of
the tray and push/pull the tray to the desired position. Tighten the knobs once the tray is in the correct
position for the user.
Before using the standing frame the knob (star grip screw) must be checked for tightness!
NOTE: If the user has fixed, flexed hips and knees, they will tend to lean forward once they are in their
upright position. With this in mind, adjust the tray forward, if necessary, to accommodate their
position. If the tray is adjusted correctly, the user will touch the safety cut-out button once they are in
a comfortable, upright position.
Knee Pads
The knee pad´s height can be adjusted by loosening the vertical latch, pos. 14 (chapter 4.2)), and its
depth by loosening the horizontal latch, pos. 15 (chapter 4.2). Knee support should be set so that the
user's knee cap will be at the centre of the pad height. Take the user's foot to knee measurement and
use this to set the height of the centre of the knee pad from the footboard. To adjust knee pad height
release the two plungers on the ends of the cross bar which carries the knee pads.
Lift or lower the knee pads to the desired height and allow the plungers to fit into the nearest set of
holes on the chromed upright tubes. Ensure the plungers have popped into place before using the
standing frame.
!
Pic. 5.7
Pic. 5.8
Pic. 5.9
