Isel LES4, Инструкция по сборке, Страница: 43 / 69

LES 4, 5, 6 - 234xxx xxxx
37 / 62 Assembly instruction
3.2.1 Reasonably foreseeable misuse
Reasonably foreseeable misuse includes
●
any use beyond the intended use.
●
the processing/use of non-approved components.
●
operation outside the specified performance data.
●
disregarding the documentation
●
unauthorized additions and modifications that impair safety
●
if faults are not rectified immediately, that affect safety
3.3 Safety instructions
WARNING!
Non-compliance with the safety instructions in the operating manual
Non-observance of the safety instructions may cause slight to severe injuries and damage to
the machine!
˃
Read this section of the operating manual carefully before connecting and commissioning
the machine!
˃
As with all technical systems, perfect functioning and operational safety of this machine
can only be guaranteed if both the generally applicable safety measures and the special
safety instructions are observed during operation.
˃
Keep the operating instruction near the machine
3.3.1 General safety instructions
Safety instructions
The following safety and hazard warnings are for your protection, the protection of third parties and the protection
of the product. You should therefore observe them without fail.
●
Observe all instructions attached to the product.
●
The safety rules and regulations of the country in which the product is used/applied must be observed.
●
The valid regulations for accident prevention and environmental protection must be observed.
●
Persons who assemble, operate, disassemble or maintain this product must not be under the influence of
alcohol, other drugs or medicines that influence the ability to react.
●
Check the product for obvious damage and only use it in a technically perfect condition.
●
The product must not come into direct contact with moisture or water. The system (the machine/plant in which
the product is installed) is only suitable for dry indoor areas. When changing from cold to warm environments,
allow the product to warm up for a few hours before use, otherwise damages from condensated water may
occur.
●
Do not install the product near equipment that generates strong electromagnetic fields. This could interfere
with the function. Avoid environments with direct sunlight, intense heat, cold, humidity or wetness.
●
Only accessories and spare parts approved by isel Germany AG may be used in order to avoid personal
hazards due to unsuitable spare parts.
●
Observe the technical data and ambient conditions specified in the product and accessory documentation.
●
Do not put the product into operation until it has been determined that the end product (for example, a
machine or system) in which the product is installed complies with the country-specific regulations, safety
regulations and standards of the application.
●
Ensure that the product is not modified or converted unless permitted in the product documentation.