Isel iPC25 - F, Руководство по эксплуатации

Страница: 11 / 15

iPC25 operating instructions
Page - 8
4 Recovering the operating system Windows® Embedded Standard 7
Important information
4.1 Preparations for restoring the operating system.
Backing up user data
Preparing USB Boot
1) To restore the Windows® Embedded operating system
Standard 7 of your control computer, you need the USB Recovery Stick supplied. This
data carrier contains an image of the operating system of your installed control
computer in the delivery state.
2) The hard disk of the control computer delivered is set to two partitions
in the factory The primary partition (approx. 40 GB) of the hard disk contains
the operating System Windows® Embedded Standard 7, while the second
partition for user data is available.
3) If you have partitioned the hard disk other than in the delivery state,
this will be returned to the delivery state when restored.
I.e only the partitions described under 2.) are created.
1) Back up your user data from all partitions to an external
data carrier (USB stick, USB HDD).
2) If you have made changes to the control configuration of your software since the
delivery please back up your current control configuration with the CNC
wbBackup wizard. This is located within the CNCworkbench entry in the Start
menu. Also save this backup on the external disk!
The backup must be done on an external data carrier,
since when restoring the operating system all partitions
are formatted and thus all data is lost.
1) After you have backed up all the data, you must use the operating system of the
recovery USB stick supplied. Plug the USB stick into an available USB port on the
computer. Switch on the computer and press the <
F12 > key at the beginning of
the boot process.

The boot menu of the computer is displayed.
2) Use the <Up / Down arrow keys> to select the USB stick in the list
Confirm your selection with the <
ENTER > key.
3) If you have set everything correctly, do not boot the installed
operating system but the operating system on the USB Stick.
Alternatively, you can also use the < Delete > key in the system start to call up
the BIOS of the computer There you have to change the boot sequence and set
the USB Recovery Stick as the first boot medium. After saving the settings, the
operating system is now started on the Recovery Stick.