3.2.3 Menu Structure
Available Menu entries are:
Entry
Subentry
Subentry
Content
CONTROL
VOLTAGE RAMP
-
Set voltage ramp speed
CURRENT RAMP
-
Set current ramp speed
CLEAR ALL EVENTS
-
Clear all events
SET KILL ENABLE
-
Set mode Kill Enable/Disable
SETUP
MEASUREMENT
ADC SAMPLE RATE
Set ADC sample rate
DIGITAL FILTER
Set digital filter steps
COMMUNICATION
CAN BUS BITRATE
Set CAN bus bitrate
CAN BUS ADDRESS
Set CAN bus ID
DISPLAY
POWER SAVE
Set display power safe mode
RESET SET VALUES
-
Reset all set values
FACTORY RESET
-
Reset all settings to factory default
HARDWARE LIMITS
-
-
Shows hardware limits V
max
and I
max.
.
This screen is automatically shown, if the
hardware limits were changed.
SUPPLY / TEMP
-
-
Shows supply voltages and temperature
INFO
-
-
Shows serial number,
firmware name and release,
nominal voltage and current
3.2.4 Editing Menu Entries
A Menu entry that has a fixed amount of possible values can be easily edited by turning the rotary encoder, the selected
value will be shown at the bottom of display screen.
A submit and save of the selected value is done by pressing the rotary encoder button.
A reset to its default value is done by pressing the right button.
A menu entry with a none-fixed amount of values e.g. voltage ramp speed is edited a little bit different.
The selected value is also shown at the bottom of the display but with a digit hilighted by a cursor. A short press on the
rotary encoder button and the cursor will jump to the next lower digit. Turning the rotary encoder changes the selected
value in the resolution of the corresponding digit.
current value
selected value
NHS – NIM standard High Voltage Power Supply | Last changed on: 01.10.2018 |
www.iseg-hv.com
10/20
