If installer is drilling their own hole, ensure that the diameter is a minimum of 1/2".
Grommet Mount Base Orientation
32"+
STEP 1
SAME FOR 24" & 30"
STEP 1
See 30"
DEEP DESK
Base
should be
forward
facing
Take the base assembly from the box and remove the angle bracket (not used in a grommet application).
Use the 7/32” Allen Key to remove the four screws holding the angle bracket to the base.
Insert the grommet bolt through the washer (
KIT C:
Arm Bolt/Washer Kit) and upward facing clamp plate (
KIT B:
Clamp Plate). From
under the desk insert the grommet bolt assembly through the desk into the center hole of the base. Use 7/32" Allen Key tighten and
secure to 75 in/lbs.
Remove
Angle Bracket
STEP 2
STEP 2
STEP 2
See 30"
DEEP DESK
Base
should be
forward
facing
24" DEEP DESK
INSTALL THE BASE REAR FACING
30" DEEP DESK
INSTALL THE BASE FORWARD FACING
BASE MUST BE IN THE REAR FACING POSITION
BASE MUST BE IN THE FORWARD FACING POSITION
4
