The unit can be installed on a 24” or 30” deep rectangular or corner desk using the integral desk clamp or grommet mounting
hardware provided. The factory setting is for a 30” deep desk clamp mount application.
Clamp Mount Base Orientation
32"+
Reverse the angle bracket. Take the base assembly from the box.
Use the 7/32" Allen Key to remove the four screws holding the angle
bracket to the base. Reposition the angle bracket per the drawing and
re-secure the angle bracket with the four screws just removed.
Using
KIT A
: Bottom Clamp Kit - attach bottom clamp to the angle bracket with the three 1/2" socket head cap screws.
Tighten with 3/16" Allen Key.
Insert the two 2" bolts into the bottom clamp. Position the clamp plate (
KIT B:
Clamp Plate) - facing up over the tips of the bolts.
Tighten alternatively each bolt to 75 in/lbs. with the 7/32" Allen Key to firmly secure the base to the desk.
STEP 1
STEP 1
STEP 1
N/A
STEP 3
STEP 3
STEP 3
N/A
STEP 2
N/A
STEP 4
STEP 4
STEP 4
N/A
Desks ¾”-1 ½” thick,
Bottom Clamp is
UPWARD
Desks ¾”-1 ½” thick,
Bottom Clamp is
UPWARD
Desks 1 ½”-2 ½”thick,
Bottom Clamp is
DOWNWARD
Desks 1 ½”-2 ½”thick,
Bottom Clamp is
DOWNWARD
Desks 1 ½”-2 ½”thick
Desks 1 ½”-2 ½”thick
Desks ¾”-1 ½” thick
Desks ¾”-1 ½” thick
Place the base in the desired location at the back of the desk. The angle bracket should slide down the back of the desk.
24" DEEP DESK
INSTALL THE BASE REAR FACING
30" DEEP DESK
INSTALL THE BASE FORWARD FACING
Base is already in the forward facing position (factory preset).
Proceed to STEP 2.
STEP 2
Base REAR facing.
Base FORWARD facing.
3
