20
R
EMOVAL
OF
L
INE
M
ODULES
FROM
C
HASSIS
C
HAPTER
7
M
ODULES
I
NSTALLATION
Check the Ordering Information for line modules to be installed.
1.
Obtain all purchased line modules.
2.
Check and insert them in the correct positions in the upper or lower slots of the deposition sections.
Line modules 1 and 3 are to be inserted before line modules 2 and 4. The iRM-4TGSFP Module is
reserved for the Slot 4 only. This module should be inserted prior to powering the module
3.
Push and turn every thumb screw until each line module is locked in position.
7.4. Removal of Line Modules from Chassis
C
ONTEXT
:
This section describes how to remove line modules.
Figure 5:
Removal of Line Modules from Chassis
To remove a line module, perform the following steps:
1.
[Optional] If the RAPTOR is installed in a rack, remove it from the rack.
2.
Loosen the screws securing the line module.
3.
Pull the module from its slot in the chassis. If all line modules are to be removed, first remove
modules 2 and 4, and then modules 1 and 3.
