62
ALARM MANAGEMENT
ERROR
BLOWER
REMOTE
CONTROL
ACTION
E1 : OVERHEAT
Red led
on OK key
blinking
Cause: Dust filter dirty or air outlet or
motor blocked.
To solve the problem, clean the filter
or remove any towels that cover the
blower, blocking the air outlet. For
safety reasons, to restore operation, it
is necessary to turn off and switch on
the blower with the switch at the
back.Then
press OK on the remote
control to update the information.
If the problem persists, contact the
local service centre.
E2
: OVERHEAT
Red led on OK key
blinking
E3 : ERROR NTC
BLOWER
Red led on OK key
blinking
Cause: NTC broken
Reset the alarm by pressing OK on
the remote control.
If the problem persists, contact the
local service centre
E4
: FILTER
CLEANING
Red led on OK key
blinking
Cause: Every 200 working hours, the
blower will automatically remind you to
clean the filter.
Clean the filter, press the START
BUTTON on the blower, holding it
down for 5 seconds. Then press OK
on the remote control to update the
information.
If the problem persists, contact the
local service centre
E5
: NTC ERROR
REMOTE CONTROL
Red led on OK key
blinking
Cause: NTC broken
Reset the alarm by pressing OK on
the remote control.
If the problem persists, contact the
local service centre
E6
:
COMMUNICATION
INTERRUPTED
Red led on OK key
blinking
Cause: Loss of communication
between blower and remote control.
Check
that the blower is switched on,
reduce the distance
between remote
control and blower. Follow the
instructions for connecting the remote
control to the blower. If the problem
persists, contact the local service
Содержание WINGS 1000
