24
- CONTINUED
TESTING ALL STATIONS
Use this feature to test all stations without affecting the program.
1. Turn dial to Station Test position.
2. To enter test time, key in a number from 1 minutes to 9 minutes.
If no time is entered, 2 minutes will be assumed.
3. Press the
Manual On/Off
key.
Each station in sequence will turn on for the number of minutes you
entered. A Fused Circuit test will occur during the station test. If a
Fused Circuit condition exists on any station, the controller will display
“Fuse” alternately with the station number. “Fuse” indicates a short on
that station.
EXAMPLE:
To test all stations for 5 min.
l
each, turn dial to
Station Test position:
STATION TEST
l
.
l
To turn on, press:
V
The
controller alternately
flashes the station number:
and the remaining test
time in minutes and
seconds:
NOTE:
Any currently active automatic watering cycles will be
suspended while the Station Test is in operation.
Upon completion or termination of the Station Test,
automatic operation will resume.
Operating the Controller Manually
DISPLAYING EXISTING
SETTINGS
Use the features in this section to display current settings without
affecting the program. For example, you can check the current time or
check the watering time for a station. The following topics are covered:
l
Displaying the time and day of the week
l
Displaying watering information
- Watering days for a program
- Total water time for a program
- Water time duration for a station
- Cycle start and end
- Current water budget percent
DISPLAYING THE TIME
AND DAY OF THE WEEK
To display the time and day of week without affecting settings:
1. Turn the dial to any program (e.g., Program 1).
2.
Press the Set Time
key to display the current time. (The current
time is also displayed when the dial is in the Auto Run position.)
3. Press the
Set Today
key to display the day of the week. The
controller displays the number corresponding to the current day of
the week, e.g., 2 for Monday.
N O T E : To change the time or day of week, see “How To Set the
Current Time and Day,” pages 8- 10.
EXAMPLE:
.
To check if the current day is correctly
entered as Monday, set the dial to any
program, such as Program 1:
Press:
For Monday, the
controller displays:
Displaying Existing Settings
25
