Page of 14
9
1. Remove the inner and outer flanges.
2. Screw the backing wheel of the sanding accessory onto the Angle Grinder spindle.
3. Select the sandpaper with the correct grit for the task.
4. Place the sandpaper on the backing wheel and then thread the paper retaining nut on and
tighten using the pin wrench whilst depressing the spindle lock.
Attaching the auxiliary handle
WARNING! Be sure to disconnect
the Angle Grinder from the power supply before
attaching or removing the disc or attachment.
The auxiliary handle should be assembled to the Angle Grinder prior to use. This is done by
screwing the threaded end of the auxiliary handle firmly into the handle mounting points on the
alloy gear case of the Angle Grinder.
Fig F
The auxiliary handle can be fitted to the left or right side of the Angle Grinder to maximize user
comfort according to the type of application being undertaken.
Choose the most appropriate position considering user comfort (preferred hand) and the task at
hand.
To reduce the risk of injury and to ensure maximum control during use, hold the tool with both
hands while the tool is in operation.
OPERATION:
Operating the on/off switch
1. To turn the Angle Grinder on, slide the on/off switch forward to the on position “1”. To turn
the Angle Grinder off, slide the on/off switch towards the rear of the Angle Grinder to the off
position “0”.
Fig G
