Page of 14
8
Grinder. The hole in the disc should be located onto the spindle. Ensure that the hole in the
disc locates and fits firmly into the ring section of the inner flange.
Fig C
11. Screw the outer flange onto the spindle with the protruding ring section facing the Angle
Grinder. This ring section must locate with the hole in the grinding disc.
Fig D
12. Tighten the outer flange by locking the spindle and tighten with the pin wrench provided.
Fig
E
13. To remove the disc, first lock the spindle and loosen the outer flange with the pin wrench.
Thereafter, remove the outer flange and the grinding disc.
Fig E
14. Regularly check that the outer flange has not loosened during use.
Attaching a wire wheel
WARNING! Be sure to disconnect
the Angle Grinder from the power supply before
attaching or removing the disc or attachment.
1. When fitting the wire wheel, the ring section on the outer flange should face into the wheel.
Similar to when fitting a grinding disc.
Attaching a sanding accessory
WARNING! Be sure to disconnect
the Angle Grinder from the power supply before
attaching or removing the disc or attachment.
