Ironton 45988, Руководство пользователя, Страница: 9 / 30

Page of 30 9
• Slide the flat washer M10 (G), roller sleeves (E),
wheels (C), and flat washer M8 (H) and nut M8 (J) onto
the axle through the hole in the center of the wheel as
illustrated. Secure in place using the wrench. (See Fig.
5)
• Repeat with the second wheel. Fig. 6 shows
completed stand assembly.
NOTE: Verity that the stand is securely locked in an
open position and that the shock adoption pad
stabilized the table saw before operation.
ATTACH THE TABLE SAW TO THE STAND (Fig. 7)
WARNING: DO NOT OPERATE THIS
MACHINE ON THE FLOOR. THIS IS A VERY
DANGEROUS POSITION.
• Place the stand on a level surface and level the stand
to the floor.
• Place the table saw on top of the stand, aligning the
holes in the base with the holes in the stand.
• Place the flat washer before insert four hex bolts
through the holes in the base and the stand.
• Tighten all four bolts with hex key.
NOTE: DO NOT OVER-TIGHTEN THE NUTS THAT
HOLD THE SAW TO THE STAND. DOING SO WILL
DAMAGE THE SAW BASE. TO SECURE/LEVEL
THE TABLE SAW (Fig. 8)
With the stand open and the table saw resting on a flat,
level surface, the table saw should not move or rock
from side to side. If the table saw rocks from side to
side, the leveling foot needs adjusting until the stand is
balanced.
• Loosen the knob counterclockwise.
• Lift the table saw slightly so that you may turn the
leveling foot until the stand no longer rocks.
• Turning clockwise will lower the foot.
• Turning counterclockwise will raise the foot.
NOTE: Only the leveling foot with nut can be adjusted