Ironton 32185, Руководство пользователя

Страница: 7 / 13

Page of 13 7
11 Button for depth stop adjustment
12 Auxiliary handle
13 Securing screw for key type drill chuck*
14 Key-type drill chuck*
15 SDS-plus adapter shank for drill chuck*
16 Depth stop
17 Front sleeve of the quick change keyless chuck*
18 Retaining ring of the quick change keyless chuck
19 Universal bit holder with SDS-plus shank*
*The accessories illustrated or described are not included as standard delivery.
Before any work on the rotary hammer itself, pull the main plug.
Selecting Drill Chucks and Tools
For hammer drilling and chiseling, SDS-plus tools are required that are inserted in the SDS-plus drill
chuck. For drilling without impact in wood, metal, ceramic and plastic as well as for screw driving
and thread cutting, tools without SDS-plus are used (e.g., drills with cylindrical shank). For these
tools, a keyless chuck or a key type drill chuck are required.
Inserting the Key Type Drill Chuck (see figure A)
Clean the shank end of the adapter shank and apply a light coat of grease. Insert the drill chuck (3)
with the adapter shank into the tool holder with a turning motion until it automatically locks. Check
the locking effect by pulling the key type drill chuck.
Removing the Key Type Drill Chuck
Push the locking sleeve (5) toward the rear and pull out the key type drill chuck (14).
Removing the Quick Change Chuck (see figure B)
Pull the lock ring for the quick change chuck (5) toward the rear, hold it in this position and pull off
the SDS-plus quick change chuck (2) or the quick change keyless chuck 1 toward the front. After
removing, protect the replacement chuck against contamination.
Changing the Tool
The dust protection cap (4) largely prevents the entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that the dust protection cap (4) is not damaged.
A damaged dust protection cap should be changed immediately. We recommend having
this carried out by an authorized service center.
Inserting SDS-plus Drilling Tools (3) (see figure C)
The SDS-plus drill chuck allows for simple and convenient changing of drilling tools without the
use of additional tools. Clean and lightly grease the shank end of the tool. Pull back locking sleeve
(5), the drill bit (3) into the tool. Check the latching by pulling the tool.
Removing SDS-plus Drilling Tools (see figure D)
Push back the locking sleeve (5) and remove the tool.
Inserting Drilling Tools without SDS-plus construction Note : Do not use tools without SDS-plus
construction for hammer drilling or chiseling! Tools without SDS-plus construction and their drill
chucks are damaged by hammer drilling or chiseling.
Insert a key type drill chuck (14).
Open the key-type drill chuck (14) by turning until the tool can be inserted. Insert the tool.
Insert the chuck key into the corresponding holes of the key type drill chuck (14) and clamp the tool
tightly.
Turn the mode selector switch (10) to the “Drilling” position.