Ironton 32185, Руководство пользователя

Страница: 10 / 13

Page of 13 10
Inserting Screwdriver Bits (see figure I)
Apply the power tool to the screw/nut only when it is switched off.
Rotating tool inserts can slip off. To work with screwdriver bits, a universal bit holder (19) with
SDS-plus shank (accessory) is required. Clean the shank end of the adapter shank and apply a light
coat of grease. Pull back on the locking sleeve (5). Insert the universal bit holder with a turning
motion into the tool holder until it automatically locks. Check the locking effect by pulling the
universal bit holder. Insert a screwdriver bit into the universal bit holder. Use only screwdriver bits
that match the screw head. To remove the universal bit holder, pull the locking sleeve (5) toward the
rear and remove the universal bit holder (19) out of the tool holder.
MAINTENANCE
•
Maintain your Rotary Hammer. It is recommended that the general condition of any Rotary
Hammer be examined before it is used. Keep your Rotary Hammer in good repair by adopting a
program of conscientious repair and maintenance. Have necessary repairs made by qualified
service personnel.
•
Before any work on the power tool itself, remove the power cord from any electrical outlet.
For safe and proper operation, always keep the power tool and the ventilation slots clean.
A damaged dust protection cap should be changed immediately. We recommend having this
carried out by qualified service personnel.
Clean the tool holder (3) each time after using.