iRay Technology MATE MAH40, Руководство по эксплуатации

Страница: 10 / 30

InfiRay Outdoor • MATE Series • User Manual www.infirayouordoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
To mount it on a day scope, please follow instructions as follows:
 Please make sure that the day device is zeroed before installation.
 Measure the outer diameter of the lens of your day scope (17) .
 Select an appropriate adapter with the internal thread M52*0.75 and an
insert of the required diameter depending on the outer diameter of your
day scope’s objective lens.
 In the package, the complimentary universal adapter (14) with four inserts
is suitable for the outer diameter from 56mm to 65 mm. If your day scope
is out of this range, you need to buy it separately.
 Install the insert (16) into the adapter (14) all the way in.
 Install firmly the adapter with the insert onto the objective lens of your day
scope (17) .
 Snap the lever (20) from the original OPEN position to the CLOSE
position. Check that the adapter firmly fits the objective lens.
 If you see there is a clearance, please:
- Loosen the locking screw (19) with the hex-nut wrench (S=2mm).
-
Tighten the screw (18) with hex-nut wrench (S=4mm) with a clamping
force necessary to ensure that the adapter fits tightly the objective
lens.
-
Tighten the locking screw (19) .
 Mount the MATE onto the adapter (14) , and
tighten the eyepiece bayonet-type ring (2)
counterclockwise to lock MATE.

After installation, if the center of MATE’s
display is not aligned with the center of your day scope:
-
Loosen the locking screw (21) with the hex-nut wrench (S=4mm).
-
Adjust the angle of the MATE to the appropriate position to align with
the center of your day scope.
-
Tighten the locking screw (21).
As a monocular
 Remove the Clip-on universal adapter (14) from MATE, then it can be