iRay Technology InfiRay Jerry-F, Руководство пользователя

Страница: 12 / 19

2.2 Power-up and Use
When using this equipment on a helmet,
you need to fix the helmet support on the
helmet. Jerry-F is compatible with various
multi-functional shrouds and hook-loop
helmets. The procedure for installing a
helmet-based Jerry-F is as follows:
Install the helmet support on the shroud.
Attach the hook-loop support of the
battery holder to the hook-loop fastener
in the middle of the rear part of the
helmet.
Align the broad side of the battery holder
with that of the hook-loop support. Press
the battery holder until it clicks.
Connect the power cable of the hook-loop
support and the helmet support, with the
female and male white points aligned.
Install the ocular lens hood on the main
body of the goggle if needed.
Align the broad side of the quick removal
interface with that of the goggle interface
on the helmet support. Then lift the main
body of the goggle upward until it clicks.
Remove the battery compartment: Pull
out the disassembly pull of the battery
holder and lift it upward. The battery
holder is removed from the hook-loop
support.
Disconnect the power cable: Fix the
female connector of the hook-loop support
and pull out the male connector of the
power cable of the helmet support.
Disassemble the hook-loop support.
Disassemble the helmet support: Press
the snap ring of the holder and pull out
the helmet support.
Before powering up the equipment, turn
on the main power of the battery holder.
Then enable I
2
night vision, turn on the
infrared switch, and enable infrared
thermal image night vision. You will see
fused images in the ocular lens.
Figure 2.4 Jerry-F used on a helmet
7
Jerry-F User Manual V1.3
The procedure for disassembling
helmet-mounted Jerry-F is as follows:
Turn off the power: Turn off the infrared
I
2
switch of the goggle and the main
power of the battery holder.
Remove the main body of the goggle:
Turn the quick-removal knob on the helmet
support and pull out the main body of the
goggle downward.