SECTION FIVE
TECHNICAL SPECIFICATIONS
Detection Range
Detection Angle
Power Supply
Maximum Switchable Load
Lamp Type
Time On Adjustment
Dusk Level Adjustment
Environmental Protection
Up to 12 metres
140º
240V ~ 50Hz
240W
2 x 240V 120W PAR 38 ES reflector lamp
5 seconds - 5 minutes
Day & night or night only operation
IP44 (suitable for outdoor use)
At this position, the unit should become operative at approximately the same level of darkness
each evening. Observe the operation of the unit. If the unit is starting to operate too early (ie. when
it is quite light), adjust the control slightly anti-clockwise. If the unit starts to operate too late (ie.
dusk), adjust the control slightly clockwise.
Continue to adjust until the unit operates as desired.
MASKING THE SENSOR LENS
To reduce the sensor coverage, preventing detection in unwanted areas, mask the sensor lens
using electrician’s tape or similar (see diagram D). For your information, the top section of the lens
covers long range detection, the bottom covers short range. Similarly, the left and right lens
sections cover the left and right detection areas respectively.
If you experience problems refer to Troubleshooting Guide.
If problems still exist, do not immediately return the unit to store.
Telephone the IQ Customer Helpline
0871 71 71 100 Weekdays 9.00am - 5.00pm
[email protected] www.iq-europe.co.uk
Qualified Customer Support Co-ordinators will be on-line to assist in resolving your query.
SF-ATS-PAR38S-B.qxd 16/05/2005 11:23 Page 7
