iPOWER TPD-800A User Manual
10
e)
"Control" controls the switch on/off: "ON" means switch on, "OFF" means switch off, "REBOOT" means
restarting the device and its default status was "NONE", the user can switch on/off single outlet, multiple-outlet
or all outlets;
f)
The load current can be read if the device equipped with ampere meter. If not, it will display" Not found"
g)
The power consumption can be read if the device equipped with power consumption meter. If not, it will display
"Not found"
h)
The corresponding value and status of temperature, humidity, smoke, water logging and door open can be read if
all this sensors are equipped. If not, it will display "Not found". The digit in red will flash if the sensors alarm.
2)
Sensor Status
View the current status of all these sensors. Details as below:
a)
"Temperature/Humidity" displays the current temperature/humidity sensor connection status and value. "Not
found" means no Temperature/Humidity sensor is connected. The digital figures in red will flash if it's over the
value to alarm.
b)
"Door" displays the connection status of door. "Not found" means no door sensors are connected. The word
"open" in red on the screen will flash if the door is opened.
c)
"Smoke alarm" displays the connection of smoke sensor, "Not found" means no smoke alarm is connected. The
word "CLOSE" or "OPEN" can be read on the screen if connected. The word "YES" in red will flash if smoke
alarm happens.
d)
"Water logging" displays the status of water sensor, "Not found" means no water sensors is connected. The word
"YES" or "NO" can be read when connected. The word "YES" in red will flash if water-logging alarm happens.
3)
Device Configuration
Configure the device series number, input outlet name as well as the interval of sequential power on/off, details as
below:
a)
" TPD-800A Address No": each device has a unique series number; the user can not normally monitor and
manage the device if the displayed figure is not the same as the device series number.
b)
" TPD-800A name": configure the device name which can reach as long as 20 bytes;
c)
Configure outlet name, it can reach as long as 35 bytes;
d)
"Sequence Interval": configure it according to specific requirement; the interval is between 0 to 255 seconds.
4)
Network
Configure IP address
、
Sub-net Mask
、
default gateway DNS according to different application environment, details
as below:
