IPG BETTER PACKAGES RSA 2024-WAT-EU, Руководство пользователя

Страница: 38 / 220

RSA2024-WAT-EU Set-Up Procedures
4-13
4.9.3 Top Tape Threading/Loading Instructions
The instructions below will assist in threading tape on the
top tape head. Top Threading diagram is located on page 4-12.
1. Put machine in Manual Mode using
Manual/Auto
selector switch (Figure 4-15, Item 1).
2. Install tape roll on to mandrel making sure the unwind
direction is counterclockwise (refer to Figure 4-14).
3. Pull tape around peel-off roller and towards the front of
the machine (Figure 4-16, Item 6).
4. Bring tape around the front of the first guide
roller (Figure 4-16, Item 8) followed by bringing the tape
back towards the second guide roller (Figure 4-16,
Item 9).
5. After threading around second guide roller, pass tape
under the third roller (Figure 4-16, Item 7) and pull
towards the front of the machine.
6. Bring the tape over the powered drive roller (Figure 4-16,
Item 6) and towards pinch roller (Figure 4-16, Item 10).
7. Thread tape under guide plate until it reaches the pinch
roller (Figure 4-16, Item 10). During this process, make
sure pinch roller is not engaged. To engage/disengage
the pinch roller, use the Tape Threading/Stop button
(Figure 4-15, Item 2) located on the control box.
8. Once tape has been passed under the pinch roller,
engage pinch roller using Tape Threading/Stop button (Figure 4-15, Item 2).
9. Press down the Tape Feed button (Figure 4-15, Item 4) to allow machine to pass
tape through tape shoe and feed out of the tape head.
10. If tape passes with no jams, remove tape from tape shoe guide, and press
Start
button (Figure 4-15,
Item 5) and hold for one second to begin machine operation. If you encounter a jam, see Clear Mode
(Clear Jam) , on page 5-7.
Figure 4-16 Top Tape Head Loading/Threading
9
8
6
7
10
11
2
Figure 4-15 Control Box - Top Threading
1
3
4
5