IPG BETTER PACKAGES RSA 2024-WAT-EU, Руководство пользователя

Страница: 50 / 220

RSA2024-WAT-EU Troubleshooting
6-1
Chapter 6
TROUBLESHOOTING
The RSA2024-WAT-EU Case Sealer is fabricated with high quality components that provide trouble-free
operation for a long period of time. However, should a problem occur, we recommend that you consult the
following table. If the problem you encounter is not discussed in this table, call Interpack Technical Support .
Trouble Possible Causes Solutions
Green start button
pressed but belts do
not turn.
E-stops not reset.
Machine not plugged in.
Machine set to manual operation.
“Clear” mode activated.
Enclosure door is opened.
Reset button has not been pressed.
Rotate both E-stops ¼-turn
clockwise ( page 5-1 ).
Plug machine into 220V, 50HZ, 10A
electrical service.
Switch machine to auto using
selector switch ( page 4-10 ).
Press clear button on control box to
deactivate clear mode ( page 4-10 ).
Close enclosure door.
Press Reset button.
Motors turn but belts do
not turn.
Belt tension too low.
Adjust tension on drive belts
( page 8-2 ).
Drive belts do not process
cases.
Belt tension too low.
“Close” PSI setting too low.
Collapsed leading end panel on case.
Case size is out of specification.
Box slipping on drive belts.
Adjust tension on drive belts
( page 8-2 ).
Adjust “Close” PSI setting to
recommended.
Adjust pressure of wipe down rollers.
Compare case sizes with machine
specifications.
Adjust “Close” PSI.
Case processes but side
of case is crushed.
Case width adjustment incorrect.
“Close” PSI setting too high.
Re-adjust case width.
Adjust “Close” PSI setting to
recommended.
Case processes but
leading end panel is
crushed.
Product does not support the end panel
of the case.
Too much pressure on wipe down
rollers.
Rear wipe arm activates before box is
processed.
Insert proper dunnage material to
provide support.
Reduce pressure of wipe down
rollers.
Case slipping or box removed after
introduction to sensor.