IPG BETTER PACKAGES RSA 2024-WAT-EU, Руководство пользователя

Страница: 47 / 220

Operating Instructions RSA2024-WAT-EU
5-4
5.3.2 Manual Mode
This mode is used for troubleshooting and loading tape on to machine.
1. Ensure that the compressed air is plugged in and at 90 PSI.
2. Turn the control selector to
Manual
mode (refer to Figure 5-6).
3. Once set to Manual , other buttons on control box can be used for troubleshooting or loading tape.
4. See Operator Control Box , on page 4-10, for an explanation of button usage.
5.3.3 Clear Mode (Clear Jam)
This mode is used to clear a jammed box without the need for the E-Stop .
Note: While in “Clear” mode, the top tape head box will return to its “home” position and the side belt
drives will not retain any pressure. The belts will cease operation but the machine will continue to
be powered throughout. If electricity needs to be cut off throughout the machine, use the E-stop
buttons located on the control box and on the top tape head box.
1.
Ensure that the compressed air is plugged in and at 90 PSI.
2.
Press downward on the Clear mode button, at the top of the control box, to set machine to
clear mode (refer to Figure 5-6).
3.
Remove jammed box.
4.
Determine location of tape jam:
a. Inspect and remove tape shoe if there is visible tape in path (refer to page 7-7 ).
b. Inspect and remove water pot to clear any tape that may remain from jam (refer to page 4-16 ).
c. Inspect tape path prior to cutter for jam, pressing down on the pinch roller to remove any remaining tape.
5.
Once box and tape have been removed, feed tape under pinch roller.
6.
Remove newly dispensed tape, press Start button, and hold for one second to begin machine operation.
WARNING: Ensure that the operator's hands are away from the moving belts of the side
drive base assembly. Do not place hands on the front edge of the case while it
is entering the machine.
Note:
-- Should any problem occur during processing that requires halting the machine, press any red
E-stop button.
-- The machine should never be washed down or subjected to conditions causing condensation on
components.
Notes