7.2.
Recording
1. Start and stop recording
2. Displays the current frame rate (frames per second). Can be reduced under <Advanced settings>, see further
below
3. Recording mode selection
Recording time: Recording stops after a set time, see point 4
Ring buffer: The first images are overwritten again after a set time– can be stopped via the stop button.
If the
capacity limit is reached before the set time, recording is stopped or the images are overwritten
4. Adjusts the recording time or the duration of the ring buffer time, entry into the text field possible
5. Makes it possible to change the unit of time
6. Adjusts the picture brightness - Entry into the text field possible
Exposure: Changes the opening time of the camera sensor - this time influences the current frame rate
(see 2)
Gain: Changes the brightness using the software - noise in the picture increases with a higher value
7. Switches to other recording options (see below)
1. Adjust the size of the picture
Lower image detail reduces the data rate to be transmitted and the frame rate is higher.
Contingent on tech-
nology, the picture height has more influence on the frame rate than the width.
Note that with very low details, a maximized display produces a very rough image!
2. The camera picture can be rotated in 90° increments at the lowest installation position. The rotation is dis-
played immediately - the complete recording is rotated after recording has ended
1
2
3
4
5
6
7
1
2
MANUAL • Subject to alteration! Version:
September 2019
ipf electronic gmbh • Rosmarter Allee 14 • 58762 Altena
│
Tel +49 2351 9365-0 • Fax +49 2351 9365-19
│
[email protected] • www.ipf-electronic.com
7
