ENGLISH
14
Fitting the brushes (two brush version):
Place the brushes under the head drive disk.
Lift the right brush with your hands and turn it clockwise, locking it in position on the drive
disk. Lift the left brush with your hands and turn it anticlockwise, locking it in position on
the drive disk.
Use of abrasive/microfibre disks: fit the abrasive/microfibre disk on the drive disk and
perform the operations described for fitting the brush on the scrubber drier.
Removing the brushes (two brush version) (or drive disk):
Raise the machine head by pushing the head lift pedal down and then to the right (fig. 6,
ref. 9). Turn the right brush anticlockwise, releasing it from the drive disk. Turn the left
brush clockwise, releasing it from the drive disk.
6.5. Detergents – Instructions
IMPORTANT
Always dilute the detergent according to the manufacturer's instructions. Do not
use sodium hypochlorite (bleach) or other oxidants, particularly in strong
concentrations. Do not use solvents or hydrocarbons. The temperature of the
water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made
specifically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section "Safety
regulations".
6.6. Preparing the machine for work
IMPORTANT
Before starting work, wear overalls, ear protectors, non-slip waterproof shoes,
mask to protect the respiratory tract, gloves and all other personal protection
devices recommended by the supplier of the detergent used or necessitated by the
work environment.
Before starting work, proceed as follows:
•
Battery models: check the battery charge (recharge if necessary);
•
lower the head by means of the pedal (fig. 6, ref. 9);
•
make sure the dirty water drum (fig. 2, ref. 2) is empty. If necessary, empty it;
•
check that the tap lever (fig. 6, ref. 6) is in the "CLOSED" position;
•
via the opening at the front, fill the detergent tank (fig. 2, ref. 7) with a suitable
concentration of clean water and low-foam detergent. Leave at least 5 cm between the
surface of the liquid and the opening of the tank;
•
if the machine is fitted with the optional CHEM DOSE accessory, remove the cap and
fill the tank (fig. 15, ref. 1) with appropriately diluted low-foam detergent.
•
mount the most suitable brushes or drive disks for the floor and work to be performed
(see paragraph 3.4);
•
make sure the squeegee (fig. 2, ref. 6) is firmly attached and connected to the suction
hose (fig. 7, ref. 4). Make sure the back blade is not worn.
i INFORMATION
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
Always empty the dirty water drum before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, follow a few simple
rules:
