GROUNDING INSTRUCTIONS
The120V A/C and the 220V A/C models have been outfitted with the appropriate grounded connectors. Make
sure the machine is connected to a grounded outlet having the same configuration as the grounded plug. No
adapter should be used with this machine. Any modification to the connectors will void the warranty.
PREPARING THE MACHINE
(ALL FASTRACT EQUIPMENT)
IMPORTANT:
For all FASTRACT equipment, use only the correct IPC high pressure, high heat wands &
upholstery tools. They are designed to deliver and maintain the correct gallons per minute (GPM), pressure
(PSI) and heat when attached to the FASTRACT pump system. Use of other manufacturer wands can cause
over-wetting of carpet, damage to the pump system (including hose & fittings), lack of pressure and heat.
1)
Pour clean solution into the solution tank
2)
Slide vacuum hose onto the black hose adapter (located at the back of the machine) and the wand or
upholstery tool.
3)
Connect the male end of the solution hose to the wand and the female end to the machine by sliding
knurled collar on the female quick disconnect fitting back. Push the male fitting in and release the
knurled collar until it snaps back.
4)
Make sure the drain valve is closed by pushing the T-handle all the way in.
5)
Previously shampooed carpets usually have a heavy build-up of old shampoo residue which can cause
the vacuum system to ingest foam and result in damage to the vacuum motor. Remember to add
recommended amount of defoamer to the recovery tank every time you fill the solution tank.
Additional Instructions for FASTRACT with a HEATER:
1)
Be sure to fill the solution tank with water before plugging in the machine.
2)
Water hookups must be in place and water flowing through the heater prior to turning it on. Failure to do
so may cause internal component damage and will void the warranty.
Spray water through the tool / wand before turning on the heater to assure that there is water
flow.
3)
Heater must be filled with water or water based solutions at all times when in use.
4)
Plug heater power cord and machine power cord into separate outlets on separate circuits.
5)
Turn off the switch and unplug the heater from outlet when not in use.
6)
Do not use heater at more than 500 PSI.
7)
Turn on heater switch when you are ready to clean.
8)
CAUTION: When the green light on the heater is on, the heater is heating. When the green light is off,
the water in the heater tank is up to temperature and the thermostat switch in the heater has turned the
heater off. It will automatically turn on again when the water temperature in the heater has cooled.
DELIVER MAXIMUM HEAT
by performing the following
SYSTEM WARM-UP PROCEDURES
at the
start of each day:
1)
Attach the solution hose to the quick disconnect on the machine.
2)
Attach the warm-up quick disconnect with spray tip attached to the other end if the solution hose.
3)
Place warm-up quick disconnect in the solution tank.
4)
Fill solution tank with cleaning solution.
5)
Turn on pump.
6)
When water is flowing out of the warm-up quick disconnect, turn on the heater.
7)
Let the pump and heater run for 4 to 5 minutes.
8)
Remove warm-up quick disconnect. Attach the wand or upholstery tool and begin cleaning.
https://harrissupplyind.com - To Order Parts Call 608-268-8080