Operating and mounting instructions
PowerBlock io64 Order number: 77024-180-03
BMA 77024-io64_Rev1_en
6/7
-
These buttons can be activated to control each and every channel/output individually if you select "yes" in the
relevant parameter options in Binary outputs and/or Shutter/Blinds.
The LEDs represent:
For Binary outputs:
The top row: channels A1, A2, B1, B2
Für Shutter/Blinds:
The top row: channel’s first relay A1->UP, A2->DOWN, B1-UP, etc.
The
inputs
of the actuator have 1 push button and 1 status LED for each input on the below LED row
-
These buttons can be activated to control each and every input individually if you select “yes” in the relevant
parameter options in Binary Input.
-
The LEDs represent: The below row inputs 1&4, 2&5, 3&6 actual input status
MANUAL CONTROL – PARAMETER
The PARAMETER Mode allows you to control all the channels of the actuator as configured in the ETS.
The Action simulates a telegram received at the switching object of the selected channel.
Binary
Shutter/Blind
Press action: Sends Toggle ON/OFF command “0/1”
to the “Switching” object
LED = EIN (Anzeige Kanal-Status)
LED = AUS (Anzeige Kanal-Status)
Long press action (Channel output 1): Sends a UP
command “0” to the “Move” object.
Long press action (Channel output 2): Sends a DOWN
command “1” to the “Move” object.
Short press action (any output) (while shutter/blind is
moving) of same button: sends a Stop command to the
"Stop…" object.
LED blinks while moving UP/DOWN during
parameterized time
Binäre Eingänge
Press action on 1&4, 2&5, 3&6: Sends Toggle ON/OFF command 0/1 to the "associated object" of the input (simulates
the close/open action on the binary contact)
LED = ON indicates input status -> Input contact closed)
LED = OFF (indicates channel status -> Input contact open)
"Man" push button in the right side for selection inputs status range between input 1..3 (LED = ON) and inputs 4..6
(LED = Blinking)
MANUAL CONTROL – TEST
