Operating and mounting instructions
PowerBlock io64 Order number: 77024-180-03
BMA 77024-io64_Rev1_en
3/7
EMC requirements
Complies with:
Overvoltage category:
EN 50491-5-2 / EN 50491-5-3
class III
Environmental conditions
Clima conditions:
Operation temperature:
Storage temperature:
Rel. humidity (non condensing):
EN 60721-3-3 class 3k5
-5°C to +45°C
-25°C to +70°C
5 % to 93 %
Certification
CE-Signage
KNX registered
According to EMC-Guidelines
(Residential and commercial
buildings), Low Voltage guidelines
Location and function of the LEDs and control elements
Mounting and wiring
As an REG device, the Power Block series are suitable for mounting in distribution boxes on 35 mm DIN rails and wall
boxes.
5
4
6.2
6.1
2
1
3
8
72mm / 4 DIN RAIL
7.1
7.2
1
: KNX bus connector
2
: Programming button
3
: Programming LED
4
: SD card slot (only for internal use)
5
: Outputs connector: Channel A,B
LED output/channel status
6.1
: Binary channel: LED ON = Output ON, LED OFF=
Output OFF. Shutter: LED blinks while moving DOWN
Blind chanal:
Long press: Move down (LED blinks while moving)
Short press: Stop / Step
Binary channel:
Short press: Output toggles ON/OFF
6.2
: Binary channel: LED ON = Output ON, LED OFF =
Output OFF. Shutter: LED blinks while moving UP
Blind chanal:
Long press: Move up (LED blinks while moving)
Short press: Stop / Step
Binary channel:
Short press: Output toggles ON/OFF
7.1
: Binary input LED ON = Contact closed, LED OFF =
Contact open
7.2
: Binary input "Manual action"/"Input 1..3 OR Input
4…6 range status selector"
8
: Inputs terminal block connector
